Статистика
Время:
Зарегистрированных: 88901
Последним зарегистрирован: serega_serega
Рекорд посещаемости: 12585
Групп пользователей: 4
 Группы:
[Admin] [Cоучастник] [Автор] [Модератор]
 Сейчас на сайте
 Всего: 450
 Гостей: 442
 Анонимных: 2
 Пользователей: 6
 Зарегистрированные:
OFF-ROAD36 Eddy71 tillman Bupa Luk OLEGA

> - антенны 110-1000 МГц -> Антенна Ground Plane 144мГц
If you are just starting out or have the desire to build an antenna here is a simple and fun project. This antenna is perfect for those hams living in the primary coverage area of the .075 repeater. The radials can be made of no. 12 copper wire. The vertical radial (A) should be soldered to the center connector of the SO239. The four base radials (B & C) and (D & E) can be soldered or bolted to the SO239 mounting holes using 4-40 hardware. The four base radials then should be bend downward to a 45 degree angle. The antenna can be mounted by clamping the PL259 to a mast or even passing the coax through a 3/4 ID PVC pipe and compression clamping the PL259. Either way let your creativity flow. If you plan on mounting it outside experience teaches to apply RTV or sealant around the center pin to keep water out of the coax.
image
Make each radial a 1/4 wave of your desired frequency. Sometimes it helps to add a little extra
length to the radials. This will give you some snipping room when you adjust the SWR.
example calculation:
Freq (mhz) A (inches) B&C/D&E (inches)
146 mhz 19-5/16 20-3/16




  banner DIPTRACE - САМЫЙ ЛУЧШИЙ ТАКСИРОВЩИК ПЕЧАТНЫХ ПЛАТ
Portal-X